Boating Safety Course Logo American Boat Operators' Course
Log In

Basic Boating Information

Return to Table of Contents

1

Video Part 1

2

Boating Terms

3

Video Part 2

4

Personal Watercraft

5

Paddlesport Boats

6

Capacity

7

Hull Identification Numbers

8

Trailers and Trailering

9

Boat Ramps

10

Weather

11

Float Plans

12

Boat Maintenance

13

Fueling

14

Environmental Considerations

15

Chapter Review

BOAT RAMP GUIDELINES

Preparation

Once you reach your destination, there are a few important items you must perform:
  • Pull off to the side and prepare your boat for launching.
  • Install the boat plug, remove tie-down straps.
  • Raise the outdrive or outboard motor to avoid damage when backing down the ramp. The steerable nozzle on a PWC cannot be raised and it is well protected when launching.
  • Disconnect trailer lights.
  • Have adequate line attached to a boat cleat on the same side as the dock you will tie-up to.
  • Load any remaining personal items or safety equipment.

Launch

Launching is best accomplished by going slow and taking your time:
  • Slowly back your boat to the ramp with the aid of a spotter.
  • Each boat launches differently, but the general practice is to lower the boat into the water to a level where the boat or PWC becomes slightly buoyant.
  • Make sure the vehicle exhaust pipes stay out of the water.
  • Place the vehicle in park and set the emergency brake.

Multiple Person Launch

  • Once the boat is in the water, one person tends the boat and trailer while another operates the boat. Lower the outboard or outdrive into the water and start the engine (not necessary for PWC). Let engine warm and check all gauges for proper operating range.
  • Remove the winch hook and safety chain from the boat's trailer eyebolt.
  • Slowly drive the boat off the trailer. Park the vehicle.

Solo Launch

  • Trailered PWC Have a line, at least 1.5 times the length of the boat, attached for tending. This allows the boat to clear the trailer ·
  • You may have to assist the boat off the trailer with a good push. ·
  • If there are others waiting to launch, moor the boat away from the launching area and then park the trailer.

Note – Sailboats have additional requirements such as securing the keel board in the up position and “stepping” (putting into position) the mast.

Recovery

  • Generally, recovery is more difficult than launching.
  • Make certain the motor or outdrive is raised.
  • Boaters may be waiting to launch, as well as recover, their boats. It is common practice to rotate turns (1 launch, then 1 recover). When it is your turn, be prepared, but take your time.
  • As soon as you dock, the vehicle driver leaves to get the vehicle. Everyone, except the driver of the boat should disembark.
  • The trailer is then backed into the water to a point where the rollers, or skids, at the back of the trailer are just under the surface of the water.
  • How far you back the trailer into the water depends on three variables (1) the angle of the boat ramp, (2) the draft of your boat, and (3) whether it is a tilt trailer or not. Once the trailer is in the water, there are two generally accepted recovery practices:
    1. The first method is to simply hand-maneuver the boat to the trailer, connect the winch cable and winch the boat into place while keeping it aligned to the trailer (no one needs to be in the boat if using this method).
    2. The second method, termed "powerloading" requires the driver operator of the boat to drive the boat up and onto the trailer. This method is somewhat dangerous as there is a chance of missing the trailer, or powering too hard and driving up and over the front of the trailer. Another problem with powerloading is that the propeller thrust can wash away the sand and gravel that supports the concrete ramp. Once there is no support for the concrete, it cracks or breaks off resulting in a steep drop-off at the end of the ramp.

Once the boat is aligned on the trailer, slowly winch it into place on the trailer (stay out of the way of the winch cable). Attach the safety chain from the trailer to the bow trailer eyebolt. If trailering a boat with an inboard/outboard or outboard motor, make certain you have raised them up enough to clear the ramp as the boat is pulled from the water. Slowly pull the boat out of the water to an area well clear of others.

PWC Trailering Checklist

Remove items from the boat and secure all loose items for the trip back home. Check winch cable one last time and tighten as necessary.
Remove the boat plug. Attach trailer lights and check.
Fasten tie-down straps. Make one last safety inspection around the boat.

From start to finish, trailering a boat requires constant monitoring. However, once you have mastered it, there are few limits to where you can boat. Boating where you want means enjoying a variety of water systems and a freedom others may never experience.

Online Users